phono preamp modification
Posted: Mon Jun 27, 2016 9:36 pm
hi fellas,
been a while since i posted in these parts.
i've got a phono preamp here, which has separate controls for 2 channels
Pics for ur viewing pleazure:
http://i63.tinypic.com/ok692e.jpg
http://i63.tinypic.com/n5r33o.jpg
http://i63.tinypic.com/ap8aav.jpg
http://i65.tinypic.com/119xeg3.jpg
http://i63.tinypic.com/16hp75l.jpg
Each channel has 1 gain pot, 1 LF control, 1 HF control.. all 3 are B100K pots, which from what i have read is just a Linear 100K pot.
so, my question, and reading it over makes it sound real dumb....
but...would I be able to replace all mono pots with a 100K Ohm Linear Dual pot like the one in this link?
http://www.ebay.com/itm/100K-Ohm-Linear-Dual-Taper-Rotary-Potentiometers-Pots-5-Pcs-TS-/172004497507
im pretty sure i'll roger the job up...as simple as it is, but i wanted to know if there are any ill effects i can expect from doing something lie this...as im not really that exprienced...
oh, and obviousl i'll need to use some terminal pins + bend a few of the pots legs to make this work...and also keep in mind i'll just have the stereo pots on one side and just seal off the controls on the other side.
Ill also need to solder some wire that goes from the pots i plac on one side to the pots i remove on the other...
also,does pro equipment require anything beefier than a regular jaycar soldering iron for desoldering duties?
been a while since i posted in these parts.
i've got a phono preamp here, which has separate controls for 2 channels
Pics for ur viewing pleazure:
http://i63.tinypic.com/ok692e.jpg
http://i63.tinypic.com/n5r33o.jpg
http://i63.tinypic.com/ap8aav.jpg
http://i65.tinypic.com/119xeg3.jpg
http://i63.tinypic.com/16hp75l.jpg
Each channel has 1 gain pot, 1 LF control, 1 HF control.. all 3 are B100K pots, which from what i have read is just a Linear 100K pot.
so, my question, and reading it over makes it sound real dumb....
but...would I be able to replace all mono pots with a 100K Ohm Linear Dual pot like the one in this link?
http://www.ebay.com/itm/100K-Ohm-Linear-Dual-Taper-Rotary-Potentiometers-Pots-5-Pcs-TS-/172004497507
im pretty sure i'll roger the job up...as simple as it is, but i wanted to know if there are any ill effects i can expect from doing something lie this...as im not really that exprienced...
oh, and obviousl i'll need to use some terminal pins + bend a few of the pots legs to make this work...and also keep in mind i'll just have the stereo pots on one side and just seal off the controls on the other side.
Ill also need to solder some wire that goes from the pots i plac on one side to the pots i remove on the other...
also,does pro equipment require anything beefier than a regular jaycar soldering iron for desoldering duties?