Ensoniq ESQ-1

Moderators: Thirteen, rick, Mark Bassett

Ensoniq ESQ-1

Postby KBnewbie » Thu Sep 22, 2011 12:12 am

I was at someones place yesterday looking to buy a guitar amp and spotted that they had an Ensoniq ESQ-1 , 1988 dated plastic cased type sitting there...they said it has not been played in years, fitted with an E2 prom cartridge...anyhow got it for $100.
Needs a replacement battery..no big deal..there is a block of 8 keys not working and two other keys not working.
Have not looked looked at schematics yet but I would suspect that the block of 8 keys not working should be easy enough to track down the cause for why they are not working and the other keys I suspect are bad contacts.
Had a quick look inside and it looks quite clean and no obvious corroded pcb tracks.
I would like to get this restored and have a bit of a play with it then turn it over.
Any one suggest a keyboard tech in Brisbane that could help with this if it gets beyond my capabilities?
Cheers,
Noel
Noel Bourne
KBnewbie
Registered User
Registered User
 
Posts: 28
Joined: Fri Jul 03, 2009 4:55 pm
Location: Brisbane Australia

Re: Ensoniq ESQ-1

Postby Futureman » Thu Sep 22, 2011 10:16 am

Before you take it to a tech...

-Take apart the keyboard pcb.
-Inspect closely the pcb tracks.. Look for a track that has blistered slightly.
-Get a multimeter set to continuity and measure all the tracks (ie from solder lug to solder lug) to verify they are good.

I had a D50 that had a bunch of keys out, and the track that had corroded looked ok visually, but failed the meter test. After it failed, I scraped away the tracks coating, and it was green corroded copper underneath.. Prob someone's lemonade 5 years ago
Mike de Vrees

Purveyor of old stuff
User avatar
Futureman
Frequent Contributor
Frequent Contributor
 
Posts: 991
Joined: Wed Mar 19, 2008 4:47 pm
Location: Sydney

Re: Ensoniq ESQ-1

Postby no-fi » Sat Sep 24, 2011 2:59 pm

try replacing the ribbon cable. The ESQ-1 I used to own came with a set of 8 dead keys, and the old ribbon cable looked a bit too bent/creased for my liking... A new ribbon cable fixed it.

battery is not too hard to replace if you can solder, but make sure you get the right replacement part. there's info online if I remember correctly.
My name is Julian Higginson and I approve of this message.
no-fi
Frequent Contributor
Frequent Contributor
 
Posts: 515
Joined: Sat Feb 23, 2008 12:21 pm
Location: sydney


Return to Vintage Synth Forum

Who is online

Users browsing this forum: No registered users and 1 guest


cron