I have a Yamaha RX11 drum machine and the left channel only outputs if I press and hold quite firmly on the volume slider. Affects both the stereo out and headphone out. I'm not the best solderer and so not that keen to replace the slider or chase up parts etc - is there anything else anyone can recommend I should try before attacking it?
Thanks!
- It is currently Fri May 17, 2024 4:06 am • All times are UTC + 10 hours [ DST ]
Dodgy Yamaha RX11 volume slider
Moderators: Thirteen, rick, Mark Bassett
3 posts
• Page 1 of 1
Dodgy Yamaha RX11 volume slider
J-u-s-t-i-n M-u-l-l-i-n-s
https://justinmullins.com.au/
https://justinmullins.com.au/
- justmull
- Registered User
- Posts: 22
- Joined: Sun Jan 03, 2010 3:12 pm
Re: Dodgy Yamaha RX11 volume slider
Not really, you probably need to re-flow the solder on the slider terminals which is not a big job, if that doesn't work then the slider needs to be removed and dismantled and cleaned or replaced.
Steve Jones
-
Thirteen - TRM Endorsed
- Posts: 1279
- Joined: Fri Dec 01, 2006 5:08 pm
- Location: Sydney
Re: Dodgy Yamaha RX11 volume slider
Hmm reflowing the solder sounds not too hard, I'll try that first. Thankyou once again Steve!
J-u-s-t-i-n M-u-l-l-i-n-s
https://justinmullins.com.au/
https://justinmullins.com.au/
- justmull
- Registered User
- Posts: 22
- Joined: Sun Jan 03, 2010 3:12 pm
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest