- It is currently Tue Apr 23, 2024 6:02 pm • All times are UTC + 10 hours [ DST ]
The smell of valves (tubes)?
Moderators: rick, Mark Bassett
18 posts
• Page 1 of 1
The smell of valves (tubes)?
Do you t'rockers notice this? It's a strange aroma - I'll call it tubaroma for want of a better term - it's not unpleasant, but it's unusual and I can taste it in the air.....
Ian Dare
- Drumstruck
- Valued Contributor
- Posts: 1589
- Joined: Fri Sep 17, 2010 12:37 pm
- Location: NSW South Coast
Re: The smell of valves (tubes)?
... probably the paint burning off the outside of the tube or could be the plastic tube sockets melting
- Junction
Re: The smell of valves (tubes)?
... yeah it worked I think for a few seconds ... but for new power tubes its quite normal for them to smell a little for a while, the painted label does actually cook, as for the melting sockets, probably not unless its some cheapass amp, decent ones will be ceramic for the power tubes at least
- Junction
Re: The smell of valves (tubes)?
Yes, if it was new I'd think that, but the unit(s) are 50 years old.... I did some searches and couldn't find anything about emissions or changes caused to the surrounding molecular structure of the air by tubes.......
- but the strange smell / taste wasn't there before these units arrived and it is there now.... perhaps it's the lingering smell of england cooking off in the fresh oz air?
I'm sure I'll find what it is when I lift the lids in a week or so - stay tubed
- but the strange smell / taste wasn't there before these units arrived and it is there now.... perhaps it's the lingering smell of england cooking off in the fresh oz air?
I'm sure I'll find what it is when I lift the lids in a week or so - stay tubed
Ian Dare
- Drumstruck
- Valued Contributor
- Posts: 1589
- Joined: Fri Sep 17, 2010 12:37 pm
- Location: NSW South Coast
Re: The smell of valves (tubes)?
Dust getting warm?
Transformer varnish warming?
Oil filled caps warming?
Transformer varnish warming?
Oil filled caps warming?
Gian Parodi
It's the first watt that counts
It's the first watt that counts
- Gian
- Frequent Contributor
- Posts: 516
- Joined: Tue Nov 18, 2008 9:38 pm
- Location: Sydney, Australia
Re: The smell of valves (tubes)?
dead rodent?
Peter Knight
Cant ego loquemur Latine
http://www.peterknightmusician.com
Cant ego loquemur Latine
http://www.peterknightmusician.com
- Wiz
- Valued Contributor
- Posts: 1147
- Joined: Thu Dec 03, 2009 10:17 pm
Re: The smell of valves (tubes)?
Interesting suggestions my good fellows.
I've read elsewhere the dust suggestion but it seems a bit unlikely on a vintage / newly rebuilt unit..... transformer varnish sounds nearer to the mark - again, I'll check when I open the lid.
That's not what oil filled caps smell like - can you still get them? Perhaps only the older crowd will know what I mean???
Dead rodent indeed - I smell a rat. Did you know that if you pick up a guinea pig by the tail it's eyes drop out? (think about it)
I've read elsewhere the dust suggestion but it seems a bit unlikely on a vintage / newly rebuilt unit..... transformer varnish sounds nearer to the mark - again, I'll check when I open the lid.
That's not what oil filled caps smell like - can you still get them? Perhaps only the older crowd will know what I mean???
Dead rodent indeed - I smell a rat. Did you know that if you pick up a guinea pig by the tail it's eyes drop out? (think about it)
Ian Dare
- Drumstruck
- Valued Contributor
- Posts: 1589
- Joined: Fri Sep 17, 2010 12:37 pm
- Location: NSW South Coast
Re: The smell of valves (tubes)?
I had a guinea pig when I was a kid, I dont remember it having a tail?
Old tube amps are like old cars, they just have a smell, be happy and sniff often
Old tube amps are like old cars, they just have a smell, be happy and sniff often
- Junction
Re: The smell of valves (tubes)?
Whats the 'offending' piece of kit?
Myles Mumford
Producer/Composer/Engineer/Sound Artist
Making records in sunny Melbourne
www.mylesmumford.com
Producer/Composer/Engineer/Sound Artist
Making records in sunny Melbourne
www.mylesmumford.com
-
mylesgm - Valued Contributor
- Posts: 1964
- Joined: Mon Feb 09, 2009 6:48 pm
Re: The smell of valves (tubes)?
you know i was in antartica once sniffing around a remote radio shed looking for pultecs ,
i found the power switch gave it a wiggle and lit up the room !
that smell is consistant even in the remotest place on earth ..!
its not the tubes actually .. its the old stuff around them , the lacquers, the bakalite the waxes the glues and gunk and the paints all that old stuff is made out of and coated in heating up .. relax enjoy it
then panic a bit when you learn the smell of it all going bad at once ..
that "this is going to be bad " smell is consistant in any part of the world as well
i found the power switch gave it a wiggle and lit up the room !
that smell is consistant even in the remotest place on earth ..!
its not the tubes actually .. its the old stuff around them , the lacquers, the bakalite the waxes the glues and gunk and the paints all that old stuff is made out of and coated in heating up .. relax enjoy it
then panic a bit when you learn the smell of it all going bad at once ..
that "this is going to be bad " smell is consistant in any part of the world as well
Rick O'Neil
I think we went to different schools together
turtlerockmastering.com
we listen
I think we went to different schools together
turtlerockmastering.com
we listen
-
rick - Moderator
- Posts: 3486
- Joined: Fri May 06, 2005 8:02 pm
- Location: Sydney
Re: The smell of valves (tubes)?
Did you find any Pultecs in Antarctica? Or anything at all? apart from penguins of course...
Myles Mumford
Producer/Composer/Engineer/Sound Artist
Making records in sunny Melbourne
www.mylesmumford.com
Producer/Composer/Engineer/Sound Artist
Making records in sunny Melbourne
www.mylesmumford.com
-
mylesgm - Valued Contributor
- Posts: 1964
- Joined: Mon Feb 09, 2009 6:48 pm
Re: The smell of valves (tubes)?
yes Rick, the bad smell also co-incides with the release of smoke ... do you know that all electronic components contain little capsules of smoke, the trick is to never let the smoke out, coz when you do it is guaranteed to stop working.
- Junction
Re: The smell of valves (tubes)?
mylesgm wrote:Whats the 'offending' piece of kit?
It's these fellows:
https://dl.dropbox.com/u/9910326/AA%20V ... everbs.jpg
the aroma is far from offensive ..... it smells like you've walked back into the early 60s - I remember similar smells from our tube tv and radio when I was a youngster and from a sonata valve guitar amp (australian made btw - i learned not to touch live valves from that unit)
Ian Dare
- Drumstruck
- Valued Contributor
- Posts: 1589
- Joined: Fri Sep 17, 2010 12:37 pm
- Location: NSW South Coast
Re: The smell of valves (tubes)?
Drumstruck wrote: it smells like you've walked back into the early 60s -
And you're complaining?
Myles Mumford
Producer/Composer/Engineer/Sound Artist
Making records in sunny Melbourne
www.mylesmumford.com
Producer/Composer/Engineer/Sound Artist
Making records in sunny Melbourne
www.mylesmumford.com
-
mylesgm - Valued Contributor
- Posts: 1964
- Joined: Mon Feb 09, 2009 6:48 pm
Re: The smell of valves (tubes)?
mylesgm wrote:Drumstruck wrote: it smells like you've walked back into the early 60s -
And you're complaining?
Not complaining about the smell at all (or the memories) - just curious as to what is generating the aroma. I think Rick is closest to the money with bakelite and old lacquers.
I'm not even complaining that my 50s and 60s pre's aren't here yet to expand the set
Ian Dare
- Drumstruck
- Valued Contributor
- Posts: 1589
- Joined: Fri Sep 17, 2010 12:37 pm
- Location: NSW South Coast
Re: The smell of valves (tubes)?
... ah nicely recycled Ferrogragh R/R pre's ... how have they done the reverb ... spring tanks?
- Junction
Re: The smell of valves (tubes)?
Junction wrote:... ah nicely recycled Ferrogragh R/R pre's ... how have they done the reverb ... spring tanks?
Yes indeedie - accutronics tanks - switchable so they function as:
- line amp only or
- line amp + verb or
- verb only
I've run a few mixes through them and early impression is that they add a lot of "bigness"
Ian Dare
- Drumstruck
- Valued Contributor
- Posts: 1589
- Joined: Fri Sep 17, 2010 12:37 pm
- Location: NSW South Coast
18 posts
• Page 1 of 1
Return to You've gotta start somewhere.
Who is online
Users browsing this forum: No registered users and 0 guests