Hi.
Has anyone use anything like these in their equipment VU's?
http://www.ebay.com.au/itm/121115117939
I don't have the 1176 Ref F's in front of me to see if there is room as these look a little wider than the 1829 bulb but it sure would be an easy way do have LED's in there..
I've heard of smashing bulbs to solder in an LED and resister but I'm all about easy.
On the topic. Colours of LED's in meters? Yellow? White?
Ta.
- It is currently Fri Apr 19, 2024 3:36 am • All times are UTC + 10 hours [ DST ]
LED meter bulbs? Is this too easy?
Moderators: rick, Mark Bassett
7 posts
• Page 1 of 1
Re: LED meter bulbs? Is this too easy?
the difficulty with leds is that often they are too bright and too directional.
you want yellowish light and you want it diffuse
since in an 1176 the lamp shoots across the top of the bezel these might work. If they aimed down across the backscale you'd get a distinct 'beam'
you want yellowish light and you want it diffuse
since in an 1176 the lamp shoots across the top of the bezel these might work. If they aimed down across the backscale you'd get a distinct 'beam'
-
rob - TRM Endorsed
- Posts: 1011
- Joined: Tue May 10, 2005 9:16 pm
- Location: Adelaide
Re: LED meter bulbs? Is this too easy?
Awesome, thanks Rob. There's only one way to find out I guess.
- Engininja
- Registered User
- Posts: 106
- Joined: Fri Jan 15, 2010 12:53 pm
-
rob - TRM Endorsed
- Posts: 1011
- Joined: Tue May 10, 2005 9:16 pm
- Location: Adelaide
Re: LED meter bulbs? Is this too easy?
You can sand the end of the led to make it more diffuse and less of a beam.
Andy Evans
http://www.mud.net.au
http://www.mud.net.au
-
Chinagraf - Valued Contributor
- Posts: 1608
- Joined: Wed Jun 22, 2005 1:09 am
- Location: Melbourne
Re: LED meter bulbs? Is this too easy?
Just had a look in an old rev G and assuming its similar to the F's, there is a bit of play in the housing so I'll have a crack. Although, this G has working screw types bulbs wedged into the bayonet mounts! I finally know why I need to give the meter a little tap to get the lights on. A nice little note too in pencil that the bulbs have been changed 7/6/81.
http://newsfeed.time.com/2011/06/16/the ... 110-years/
great tip on sanding the tip.
http://newsfeed.time.com/2011/06/16/the ... 110-years/
great tip on sanding the tip.
- Engininja
- Registered User
- Posts: 106
- Joined: Fri Jan 15, 2010 12:53 pm
Re: LED meter bulbs? Is this too easy?
yes i've sometime cut the tips off standard 5mm leds and then roughened the surface with course grit paper. Or used hot glue to make a diffuser
-
rob - TRM Endorsed
- Posts: 1011
- Joined: Tue May 10, 2005 9:16 pm
- Location: Adelaide
7 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 4 guests