Hi all,
I need to make an extender card for a bit of outboard I'm repairing for myself.
Who would you recommend for a 1 off PCB ?
Cheers
Mike
Sydney
- It is currently Fri Apr 19, 2024 2:13 pm • All times are UTC + 10 hours [ DST ]
PCB manufacture - 1 off - extender card
Moderators: rick, Mark Bassett
6 posts
• Page 1 of 1
PCB manufacture - 1 off - extender card
Mike de Vrees
Purveyor of old stuff
Purveyor of old stuff
-
Futureman - Frequent Contributor
- Posts: 994
- Joined: Wed Mar 19, 2008 4:47 pm
- Location: Sydney
Re: PCB manufacture - 1 off - extender card
What's the connector, pin configuration? I may have a stock extender available.
Bruce Maddocks
Old time audio dude
OST Mastering
Old time audio dude
OST Mastering
- Analogaudioguy
- Registered User
- Posts: 62
- Joined: Wed Apr 30, 2014 10:02 am
Re: PCB manufacture - 1 off - extender card
Thanks!
PCB edge connector , 0.1" spacing.
30 pole. (15 each side)
PCB edge connector , 0.1" spacing.
30 pole. (15 each side)
Last edited by Futureman on Sun Apr 12, 2015 9:47 pm, edited 1 time in total.
Mike de Vrees
Purveyor of old stuff
Purveyor of old stuff
-
Futureman - Frequent Contributor
- Posts: 994
- Joined: Wed Mar 19, 2008 4:47 pm
- Location: Sydney
Re: PCB manufacture - 1 off - extender card
Hard to upload pics from phone..
But would suit this connector
http://pages.ebay.com/link/?nav=item.vi ... 0888497123
But would suit this connector
http://pages.ebay.com/link/?nav=item.vi ... 0888497123
Mike de Vrees
Purveyor of old stuff
Purveyor of old stuff
-
Futureman - Frequent Contributor
- Posts: 994
- Joined: Wed Mar 19, 2008 4:47 pm
- Location: Sydney
Re: PCB manufacture - 1 off - extender card
vero board ?
-
rob - TRM Endorsed
- Posts: 1011
- Joined: Tue May 10, 2005 9:16 pm
- Location: Adelaide
Re: PCB manufacture - 1 off - extender card
I'm waiting on bits, but I'm going to make one with a connector + ribbon cable + vero.
Thanks ya'll.
Thanks ya'll.
Mike de Vrees
Purveyor of old stuff
Purveyor of old stuff
-
Futureman - Frequent Contributor
- Posts: 994
- Joined: Wed Mar 19, 2008 4:47 pm
- Location: Sydney
6 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 9 guests