Brisbane's newest studio

An audio community like no other.

Moderators: rick, Mark Bassett

Brisbane's newest studio

Postby andygriffiths » Sat Jul 09, 2016 9:21 pm

Hey Everyone,

Just thought I'd share will you will my last 12-18months. I have been setting up a new studio for a client. It's now open & ready for clients. I did all the wiring, installed all the acoustic treatment ( I even made some as well) , had rack units made up & did finish a little bit of the building work after the builder went under. I'll try & post some pictures when I can get some wifi & my laptop.


https://www.facebook.com/Red-Engine-Rec ... 674906140/
Andy Griffiths- onthebeatstudios & Andy's custom cables
http://www.onthebeatstudios.com
http://www.andyscustomcables.com
andygriffiths
Regular Contributor
Regular Contributor
 
Posts: 300
Joined: Fri Apr 13, 2012 11:30 am
Location: Brisbane

Re: Brisbane's newest studio

Postby andygriffiths » Sun Jul 10, 2016 10:37 am

Ok, so when I was first contacted by the owner the control room was based around a TOFT32 but after the slab & frame went up he bought a SSL 4040E which has been sitting in a unopened box for 3-5years. So to cut a long story short it wouldn't fit between the CR door & a wall to the bar so I had to cut a hole in the side of the CR to fit the console into the CR. The SSL has to be one of the cleanest looking boards I have every seen. No rips or cracks in the arm rest. Out of 40 ch strips only 2 needed a little work (thanks Rob & Warren Hux). Also a slate card in the Master Section needed work as well. The owner also bought a Atomic PSU which is amazing & way less noisy than the original SSL one. All in all a very smooth install which had the potential to go way wrong!
Andy Griffiths- onthebeatstudios & Andy's custom cables
http://www.onthebeatstudios.com
http://www.andyscustomcables.com
andygriffiths
Regular Contributor
Regular Contributor
 
Posts: 300
Joined: Fri Apr 13, 2012 11:30 am
Location: Brisbane

Re: Brisbane's newest studio

Postby gigpiglet » Sun Jul 10, 2016 10:57 am

toft 32 to SSL 40!
bit of a jump!
Gareth Stuckey
gigpiglet productions:presents:recordings
gigpiglet
Valued Contributor
Valued Contributor
 
Posts: 1153
Joined: Tue Jun 01, 2010 4:10 pm
Location: sydney australia

Re: Brisbane's newest studio

Postby andygriffiths » Tue Jul 26, 2016 7:36 pm

Here's a picture of the tracking room
You do not have the required permissions to view the files attached to this post.
Andy Griffiths- onthebeatstudios & Andy's custom cables
http://www.onthebeatstudios.com
http://www.andyscustomcables.com
andygriffiths
Regular Contributor
Regular Contributor
 
Posts: 300
Joined: Fri Apr 13, 2012 11:30 am
Location: Brisbane

Re: Brisbane's newest studio

Postby andygriffiths » Tue Jul 26, 2016 7:37 pm

The SSL in all it's glory
You do not have the required permissions to view the files attached to this post.
Andy Griffiths- onthebeatstudios & Andy's custom cables
http://www.onthebeatstudios.com
http://www.andyscustomcables.com
andygriffiths
Regular Contributor
Regular Contributor
 
Posts: 300
Joined: Fri Apr 13, 2012 11:30 am
Location: Brisbane

Re: Brisbane's newest studio

Postby andygriffiths » Tue Jul 26, 2016 7:38 pm

another shot of the tracking room
You do not have the required permissions to view the files attached to this post.
Andy Griffiths- onthebeatstudios & Andy's custom cables
http://www.onthebeatstudios.com
http://www.andyscustomcables.com
andygriffiths
Regular Contributor
Regular Contributor
 
Posts: 300
Joined: Fri Apr 13, 2012 11:30 am
Location: Brisbane

Re: Brisbane's newest studio

Postby andygriffiths » Tue Jul 26, 2016 7:40 pm

Another shot of the SSL
You do not have the required permissions to view the files attached to this post.
Andy Griffiths- onthebeatstudios & Andy's custom cables
http://www.onthebeatstudios.com
http://www.andyscustomcables.com
andygriffiths
Regular Contributor
Regular Contributor
 
Posts: 300
Joined: Fri Apr 13, 2012 11:30 am
Location: Brisbane


Return to The Turtlerock Forum

Who is online

Users browsing this forum: No registered users and 6 guests


cron