Turtlerock Forum

I have a rather well traveled set of AD16's that could use a going over. The level/over indicators do
stupid things on channel 7 as well. I don't suppose anybody can recommend a place to have it
serviced/repaired? From all accounts, Apogee Digital are flawless in this regard but I'd prefer
not to post it overseas.

While we are at it, does anyone know if the AD16 has a factory reset function?

You could always ask Howard Jones. http://stusol.com/service.htm

[quote="Sammas"]

While we are at it, does anyone know if the AD16 has a factory reset function?[/quote]

Power it up while holding the 'down' button in.

Cheers, Glen! I'll give them a try.

Chinagraf wrote:

Sammas wrote:
While we are at it, does anyone know if the AD16 has a factory reset function?

Power it up while holding the 'down' button in.

I stumbled on the same info! This is just a AD16 though, not the AD16x.

It doesn't have a 'down' button. I figure on of the buttons must do it though
so I'll just try all of them one by one.

Isn't it the bottom button out of the four in the cross shape over the left side front panel? You sure you didn't buy those Chinese Apochee converters by mistake?
This is the closest I oculd find to Chinese smilie. I think it is some sort of Pickachoo..

Chinagraf wrote:Isn't it the bottom button out of the four in the cross shape over the left side front panel? You sure you didn't buy those Chinese Apochee converters by mistake?
This is the closest I oculd find to Chinese smilie. I think it is some sort of Pickachoo..

The AD16x has the cross shape.


The AD16 looks like this:
[url]
http://support.apogeedigital.com/images ... p_supp.jpg[/url]

No "down" or even up... each button has a specific function.

Oh, ok..now I get it. I thought we were talking about the x series. I must stop drinking so early in the day.

vodka with orange juice is still orange juice...