FS: Reverb, preamps, splitters.
Posted: Wed Nov 27, 2013 12:30 pmClearing out some stuff!
- TC Electronic Reverb 4000. $1050
Great condition, a small amount of rack rash.
- 2x Presonus D8 8 channel mic preamps. $300 each.
Great condition, a small amount of rack rash. Both less than a year old.
- 2x ART S8 2-way microphone splitters. SOLD
A few scuffs but fully function! 1x direct out & 1x transformer out. Perfect for splitting the signal straight from stage mics to a recording rig and front of house.
Buy the 2 D8's and the 2 S8's and you can take them for $760!
- Ensoniq DP4. $220.
Physically and cosmetically its in good condition. Some rack rash. The large encoder knob snapped off it at some point in time and has been glued back on. It still functions as intended, but can probably be replaced without much fuss if you are so inclined.
- 2x Calrec PQ1253-8 Mic Preamp/EQ modules in rack. SOLD
This project has sat idly by for much too long. Untested, but in great condition physical condition. Lundahl transformers! Edge connectors included, but no PSU or wiring done inside the rack. There is documentation on the web about racking these modules.
Pickup in Sydney is preferred.
Happy to ship at buyers expense.
Buyer pays paypal fees.
- TC Electronic Reverb 4000. $1050
Great condition, a small amount of rack rash.
- 2x Presonus D8 8 channel mic preamps. $300 each.
Great condition, a small amount of rack rash. Both less than a year old.
- 2x ART S8 2-way microphone splitters. SOLD
A few scuffs but fully function! 1x direct out & 1x transformer out. Perfect for splitting the signal straight from stage mics to a recording rig and front of house.
Buy the 2 D8's and the 2 S8's and you can take them for $760!
- Ensoniq DP4. $220.
Physically and cosmetically its in good condition. Some rack rash. The large encoder knob snapped off it at some point in time and has been glued back on. It still functions as intended, but can probably be replaced without much fuss if you are so inclined.
- 2x Calrec PQ1253-8 Mic Preamp/EQ modules in rack. SOLD
This project has sat idly by for much too long. Untested, but in great condition physical condition. Lundahl transformers! Edge connectors included, but no PSU or wiring done inside the rack. There is documentation on the web about racking these modules.
Pickup in Sydney is preferred.
Happy to ship at buyers expense.
Buyer pays paypal fees.