FS: JLM Audio PEQ500 w. Hybrid API opamps

[bentolliday]

Howdy folks,

I'm selling one of my JLM Audio PEQ500 EQ modules, with custom Hybrid opamps (tighter, punchier API flavour). I've owned this modules since new, and it's in mint condition.

Here's a link to the eBay listing, with pics:

http://www.ebay.com/itm/JLM-Audio-PEQ50 ... 1115406373?

Below is a description of the unit from the JLM Audio site:

PEQ500 is a full Pultec EQP-1A & EQP-1R type passive EQ circuit combined but with 8 extra low frequencies and 5 extra high frequencies. The Q (bandwidth) control for the high boost bell curve can go twice as wide as a normal Pultec and it can also do one thing I have never seen on any other Pultec or clone do. Pushing on the Q control will switch the high boost to a shelf with the Q control still varying the slope going into the shelf.

Features:

EQ In / out toggle switch with blue LED
Electronic Balanced discrete opamp input to allow for large input levels.
High Cut shelf from 0 to -16dB switchable to 5kHz, 10kHz, 20kHz.
High Boost bell / shelf with variable Q / Slope from 0 to +16dB switchable 1kHz, 1k5kHz, 2kHz, 3kHz, 4kHz, 5kHz, 8kHz, 10kHz, 12kHz, 16kHz, 20kHz, 25kHz.
Push on Q control switches from high boost bell to shelf with orange LED lit when in shelf mode
Low Cut shelf from 0 to -16dB switchable 10Hz, 20Hz, 30Hz, 40Hz, 60Hz, 80Hz, 100Hz, 120Hz, 160Hz, 200Hz, 240Hz, 300Hz.
Low Boost shelf from 0 to +16dB switchable 10Hz, 20Hz, 30Hz, 40Hz, 60Hz, 80Hz, 100Hz, 120Hz, 160Hz, 200Hz, 240Hz, 300Hz.
Huge output transformer (same size as Neve LO1166).
Internal jumper for output ground lift.
Internal JLM 8 buss connector with jumper settings.
Double sided Gold plated rear edge connector.