Reslo Ribbon Mic repair
Posted: Thu Oct 02, 2008 12:11 amI bought Reslo Ribbon 30/50ohm from ebay - it was one of those 'what the heck' purchases as I know nothing about them and only a little more about ribbon mics.
The seller assured me it was in working condition. It had the original reslo 3 pin connector so I got a tuchel 3 pin, along with my soldering iron and all the info I could find on the net and away I went. I have now tried a few different wiring configs and the most I can get is a hum. Maybe it's just me but the wiring documentation is vague to say the least.
Can anybody help me get this baby fired up? I have attached a link to a pic and a pdf for the mic:
http://www.box.net/shared/o48dhb2zly
Plz try to keep it simple - colours and numbers are good.
kind regards
Dale
The seller assured me it was in working condition. It had the original reslo 3 pin connector so I got a tuchel 3 pin, along with my soldering iron and all the info I could find on the net and away I went. I have now tried a few different wiring configs and the most I can get is a hum. Maybe it's just me but the wiring documentation is vague to say the least.
Can anybody help me get this baby fired up? I have attached a link to a pic and a pdf for the mic:
http://www.box.net/shared/o48dhb2zly
Plz try to keep it simple - colours and numbers are good.
kind regards
Dale