- It is currently Mon Jul 27, 2026 3:49 pm • All times are UTC + 10 hours [ DST ]
Plywood Panels and CNC
Moderators: rick, Mark Bassett
3 posts
• Page 1 of 1
Plywood Panels and CNC
by Barney Loveland » Sun Sep 28, 2014 11:56 pm
Looking into using some 2.4 x 1.2m 18mm plywood panels, either a veneer or furniture grade hoop or birch panels as part of a room build. Will be mostly cut out as a frame but have some 'slats'. Figured it might be easier than building a frame from scratch. Anyone done this before? Or have any contacts in Melb? Thx.
Barney Loveland
- Barney Loveland
- Frequent Contributor
- Posts: 523
- Joined: Mon May 09, 2005 5:28 pm
- Location: Melbourne
Re: Plywood Panels and CNC
by simonstav » Mon Sep 29, 2014 9:07 pm
Hey Barney,
Can help you in Geelong. One of the guys who works for me works in a joinery and they CNC plywood all day. I do their shop fit out deliveries for them and they do all their furniture CNC'd out of ply. They even CNC'd ply for locking bar tracks in the back of my truck. Give me a buzz if you want me to hook you up or if you have a drawing you want quoted.
Can help you in Geelong. One of the guys who works for me works in a joinery and they CNC plywood all day. I do their shop fit out deliveries for them and they do all their furniture CNC'd out of ply. They even CNC'd ply for locking bar tracks in the back of my truck. Give me a buzz if you want me to hook you up or if you have a drawing you want quoted.
Regards Simon
- simonstav
- Regular Contributor
- Posts: 265
- Joined: Sun Oct 23, 2005 1:27 am
- Location: Geelong VIC
Re: Plywood Panels and CNC
by Barney Loveland » Mon Sep 29, 2014 10:05 pm
Thx, finalising plans now. Will contact you.
Barney Loveland
- Barney Loveland
- Frequent Contributor
- Posts: 523
- Joined: Mon May 09, 2005 5:28 pm
- Location: Melbourne
3 posts
• Page 1 of 1
Return to The Turtlerock Forum
Who is online
Users browsing this forum: No registered users and 22 guests