by Alastair Reynolds » Wed Jul 06, 2011 2:11 pm
As Rob said early on in the thread, different moods, different music will dictate what speaker/amp setup is used.
Sometimes it's nice to hear something as it would have been heard when it was recorded or mixed, e.g. early Beatles recording through Otto's Altec 604s will sound a lot closer to how they heard it and be in context as such. Later Abbey Road recordings may sound more "Authentic" on a Tannoy / Lockwood setup so Rob's HPD 385 Ardens would probably hit the mark. JBLs for that 70s "West coast" sound ,Something Horn Loaded for stuff out of Nashville mixed on Westlake Horns. Then drive them off an amp of the era. A really tight Mosfet amp with high damping on a mid 60s speaker is going to sound flat as the mechanical characteristics of the speaker were probably designed to run with a transformer coupled valve amp or early capactively coupled germanium bipolar amp . More modern speakers driven off a tightly controlled amp may sound pretty ordinary on an old amp, and "flap around" with heavy bass without the mechanical damping of a tight spider / surround.
It is all very subjective and the room will of course affect the sound.
It's a bit like "what guitar sounds good on what amp and with a Celestion Blue Bulldog or a JBL K120 or a Jensen Alnico" Different music needs different setups
or maybe I should "get my hand off it it" before it's too late
So here goes.
General Listening:- B&W 802 matrix with Talk Electronics Hurricane amp
Chamber Music -- String or Woodwind ensemble Quad ESL57 Electrostatic with Quad II /22 Amps or Rogers LS3/5A on the Quads--nice for spoken word too.(Been Listening to the Quads a lot lately)
For Mono stuff, Altec 601-8D or Tannoy DMT-10 driven by Mono Quad II/ QCII Pre-power amps or sometimes just one of the ESL57 (Mono on a single point -source driver is pretty neat)
Sometimes old JBL 4320s on a Fisher X100C Valve power Amp -- good for 60s Pop/rock
Orchestral-- Revox Agora Active 3 way on Revox Preamp and bitstream CDplayer--Very flat,clean
Studio Work JBL 4412 or Tannoy DMT 8 Active in mid field.
and a nice set of Auratones from the 70s for good measure.
Party Time.... Tannoy Super-dual SBX10.3 with 12.3 Subs on an array of trusty old Phase Linear, QSC and Bryston poweramps.
Some stuff sounds great on one set of speakers and crap on another and vice versa.
Had a couple of sets of Klipsch over the years. A pair of La Scalas and later Belle Klipsch. But they were so damned big and you had to get a good 30 feet from them to really get the image and bottom end. Good Horn loaded speakers do sound pretty amazing, be they Klipsch or Tannoy GRF or a similar corner Horns.
my 3c worth today....
What's your take on it Rick ?
Alastair Reynolds
Broadcast Radio Engineer
Master of the Dark Arts (Broadcast)