Upon recieving my MXP-3000, i found that the mains power loom is missing & I only have the 35ft automation loom ([b] which i have no power supply for - If anyone has a +/- 18v and +/- 8 or 9v power supply .giers a yell )[/b] ... which I have cut in half to use for mains power - problem is... main power has 2x 15 pin CinchJones outputs ( audio & prerpheral). One is 7 core ( I can use the chopped off excess from automation loom - they are the same ... BUT one is 9 core.
Can anyone recomend where I'd find this type of 9core cabel/loom rated approx 15-20A and about 2.5mm ???
Rick,Rob,Otto ... anyone ???
- It is currently Mon Jul 27, 2026 7:23 am • All times are UTC + 10 hours [ DST ]
MXP-3000 power loom
Moderators: rick, Mark Bassett
3 posts
• Page 1 of 1
MXP-3000 power loom
by tonymite » Tue Jun 07, 2005 5:37 pm
- tonymite
- Registered User
- Posts: 135
- Joined: Tue Jun 07, 2005 5:28 pm
- Location: Melbourne AU
by ottowr » Wed Jun 08, 2005 1:35 pm
You can get suitable multiple core cable from any electrical trade supplier, e.g. Auslec, Turks, L & H etc.
The connectors you'll have to get from Farnell, RS or another electronic component supplier, or Sony.
The connectors you'll have to get from Farnell, RS or another electronic component supplier, or Sony.
- ottowr
- TRM Endorsed
- Posts: 23
- Joined: Sat May 07, 2005 1:53 pm
- Location: Sydney
3 posts
• Page 1 of 1
Return to The Turtlerock Forum
Who is online
Users browsing this forum: No registered users and 21 guests