• It is currently Mon Jul 27, 2026 5:55 pm • All times are UTC + 10 hours [ DST ]

Soundcraft 6000 help

An audio community like no other.

Moderators: rick, Mark Bassett

Post a reply

Soundcraft 6000 help

Postby andygriffiths » Fri Nov 28, 2014 5:14 pm

Hi everyone,

Not sure if I should have put this post in the DIY section. I'm making some EDAC looms for a client for his 6000 series console. I have all the pinouts for the connectors which is all good. I'm just a little confused on the tie line pinout as there is hot & cold pins but no GND. If wondering if someone on here might know what pin letter I'm meant to use for the GND. I have included the pinout. Any thoughts on this would be great.
You do not have the required permissions to view the files attached to this post.
Andy Griffiths- onthebeatstudios & Andy's custom cables
http://www.onthebeatstudios.com
http://www.andyscustomcables.com
andygriffiths
Regular Contributor
Regular Contributor
 
Posts: 300
Joined: Fri Apr 13, 2012 11:30 am
Location: Brisbane
Top

Re: Soundcraft 6000 help

Postby dave01.cooper » Sun Nov 30, 2014 12:38 am

Hey Andy

Easiest thing to do if you don't have the right info on the pinouts is to open up the console/channel strip if possible & see where the grounds connect to via the edac points. Should all be tied to some buss bar somewhere. If no easy wire to follow, ye old continuity test might show you where!

Happy wiring :)
Dave Cooper

E - dave @ soundmachinestudios . com . au
W - soundmachinestudios.com.au
dave01.cooper
Regular Contributor
Regular Contributor
 
Posts: 448
Joined: Wed Oct 06, 2010 3:49 pm
Location: Melbourne
Top
Post a reply

Return to The Turtlerock Forum

Who is online

Users browsing this forum: No registered users and 17 guests